E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a front bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a rear bumper
      Removal and installation of the back shock-absorber
      Removal and installation of a cover of a fairing
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and trunk lid installation
      Trunk lid adjustment
      Removal and installation of the lock/cylinder of the lock of a trunk lid
      Removal and installation of a gas-filled emphasis of a cowl/trunk lid
      Replacement of moldings and model emblem
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation of an electric window regulator
      Removal and installation of the electric motor of a window regulator
      Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ electric equipment Schemes


2b332cca

Removal and installation of an electric window regulator

 REMOVAL

1 Remove facing of a door and a door cover in a back part, address to appropriate section.
2 Unscrew screws of fastening of glass to a window regulator, displace glass completely up and fix two wedges from within.
3 Unscrew nuts of-2-and-3-fastenings of the back tire of a window regulator-1-. Previously remove hermetic from a nut-3-.
4 Take out the tire back a window regulator inside down and put in doors.

5 Cut off a collar of a cable-1-.

6 Take out a clip - 2-.
7 Rasstykuytes I will corrode - 3-.
8 Unscrew nuts-4-and-5-.
9 Take out the forward tire of a window regulator-6-with the electric motor - 7-inside down and put below in doors.
10 Take out a window regulator from a door. Thus at first take out a forward part through an opening in a door leaf.


 INSTALLATION

11 Insert a window regulator into a door and displace a finger through an opening in a door leaf.
12 Fix a window regulator the moment of 8 N • m. Behind on the bottom nut put hermetic.
13 Join the socket at the electric motor.
14 Fix a clip for directing a cable on a door leaf.
15 Fix top directing with a new collar of a cable on a door leaf.
16 Fix glass screws and adjust, address to appropriate section.
17 Establish door facing, address to appropriate section.