E46 series BMW 3

1 Remove trunk lid facing, address to the Section Removal and installation of facing of a trunk lid.
2 Remove the holder of a lamp of the right back lamp, address to the Section Replacement of filament lamps of external lighting.
3 Disconnect a cable of a back lamp at a cover of the cylinder of the lock.

4 Unscrew two screws of fastening of a cover of the cylinder of the lock. Delay a cover on the right side from a leaf and disconnect it from an opening. Take out a cover sideways from directing and remove. 5 Rasstykuytes I will corrode - 1-.

6 Remove blocking-2-and disconnect draft-3-at the lock cylinder.
7 Turn out screws-5-.
8 Turn the lock cylinder to the right so that the directing stood in leaf cuts, then remove the cylinder down.
9 Rasstykuytes I will corrode at the trunk lid lock.

10 Unscrew screws of fastening of the lock in a trunk lid and take out through an opening in a leaf.

11 Disconnect blocking of draft of a drive, disconnect draft and take out the lock.

12 Connect draft to the lock, connect blocking.
13 Insert the lock and fix it screws. Join the socket.
14 Insert the lock cylinder into body cuts, turn on the left and fix. If the cylinder of the lock is replaced, replace the rubber plug in a trunk lid.

Check operation of the lock and the cylinder at an open trunk lid.

15 Connect the lock to draft of a drive, restore blocking.
16 Join the socket.
17 Enter a cover of the cylinder of the lock at the left in directing, press on the right and latch. Fix a cover two screws.
18 Connect electric wires of a back lamp at a cover.
19 Establish the holder of a lamp of a back lamp, address to the Section Replacement of filament lamps of external lighting.
20 Establish trunk lid facing, address to the Section Removal and installation of facing of a trunk lid.