Removal and installation/check of shock-absorbers of a bumper
REMOVAL
1 Remove the forward shock-absorber.
2 Disconnect the shock-absorber-1-. For this purpose unscrew nuts-3-.
On a place of nuts-3 - there can be rivets. In this case them it is necessary засверлить. Unscrew nuts-2-and take out the shock-absorber. If there is a connector of a cable-4-, previously open it and turn on.
CHECK
3 Measure length of the shock-absorber from the center of a plastic insert to a basic surface. If the received value less than 127.5 ± 1 mm, replace the shock-absorber.
INSTALLATION
4 Insert into place the shock-absorber and fix it the moment of 50 N • m (a key on 13 mm) or 10 NChM (a key on 8 mm) or приклепайте usual explosive rivets. 5 Fix a cable connector if he acted in film and fix a cable. 6 Establish a front bumper.
