E46 series BMW 3
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
General information and security measures
+ Leaving and repair of damages of a body
- External elements of a body
Removal and installation of a front bumper
Removal and installation/check of shock-absorbers of a bumper
Removal and installation of a rear bumper
Removal and installation of the back shock-absorber
Removal and installation of a cover of a fairing
Removal and installation of a forward wing
Removal and cowl installation
Cowl adjustment
Removal and trunk lid installation
Trunk lid adjustment
Removal and installation of the lock/cylinder of the lock of a trunk lid
Removal and installation of a gas-filled emphasis of a cowl/trunk lid
Replacement of moldings and model emblem
Removal, installation and door adjustment
Removal and installation of facing of a door
Removal and installation of the lock of a door
Removal and installation of the cylinder of the lock
Removal and installation of the external handle of a door
Removal, installation and window adjustment
Removal and installation of an electric window regulator
Removal and installation of the electric motor of a window regulator
Removal and installation of a mirror of an external look / sound signal of a high-pitch tone
Removal and installation of glass of a mirror
Removal and installation of the case of a mirror of an exterior
+ Internal elements of a body
+ Onboard electric equipment
+ electric equipment Schemes
|
Replacement of moldings and model emblem
Replacement of moldings
Moldings are fixed on body elements by plastic brackets.
1 Separate a molding a hand or a wide plastic wedge.
2 As a rule, at office of moldings plastic fillers act in film together with brackets. Therefore at first remove from pins of the plug and insert them into openings of the corresponding elements of a body.
3 Correct pognuty moldings before their installation into place.
4 Then a molding with brackets correct and fix according to openings. If necessary insert pins in palm blows.
Replacement of a firm emblem of model on a trunk lid
|
5 Separate a firm emblem of model from a body by means of thin a nylon thread (a fishing scaffold) and remove. For simplification grease a thread with detergent and fix on both ends wooden whetstones. An emblem slightly heat up the hair dryer. |
6 Remove the glue remains with alcohol or a cleaner, for example, “3М Adhesive Cleaner”.
7 New emblem heat up the hair dryer to temperature near +50°С, remove protective paper, correct and approximately on 10 with strongly press.
Replacement of an emblem of BMW
8 Carefully a screw-driver remove BMW emblem, for protection of a paint and varnish covering enclose a rag.
9 For the best skhvatyvaniye before installation under an emblem put sealing weight for a body. |
|
