E46 series BMW 3

since 1998 of release

Repair and car operation



E46 series BMW 3
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
+ RKPP and transmission line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures
   + Leaving and repair of damages of a body
   + External elements of a body
   - Internal elements of a body
      Removal and installation of forward peaks of the dashboard
      Removal and facing installation forward parts of the region of feet
      Removal and installation of the left ware box
      Removal and installation of the right ware box
      Removal and installation of the central console
      Removal and installation of the central armrest
      Removal and installation of a pocket of the console of switches
      Removal and installation of the console of switches
      Removal and installation of the electric motor of a drive of the movable panel of a roof
      Removal and installation of a mirror of an interior
      Interior mirror with automatic blackout
      Removal and installation of lateral facing of a luggage carrier
      Removal and installation of facing of the back panel
      Removal and installation of facing of a trunk lid
      Removal and installation of a head restraint of a forward seat
      Natyazhitel of a seat belt. Main data and security measures
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of nozzles of a stekloomyvatel
      Adjustment of nozzles of a stekloomyvatel
      Removal, installation and check of nozzles of a faroomyvatel
      Removal and installation of levers of a screen wiper
      Removal and installation of the tank/pump of a washer
+ Onboard electric equipment
+ electric equipment Schemes


2b332cca

Removal and installation of levers of a screen wiper

 REMOVAL

1 Moisten a windscreen with water.
2 Include for short time a screen wiper and stop it the switch. Thus the cleaner stops in a starting position.
3 Disconnect a negative cable (-) the storage battery at the switched-off ignition. The battery is in a luggage compartment behind a cover on the right side. At BMW 318i cars the battery settles down in an impellent compartment.

As a result of shutdown of the storage battery data from memory of malfunctions of some monitors are erased. If necessary before shutdown of the battery it is necessary to consider these memories of malfunctions. Address to the Section Diagnostics of malfunctions. Work it is desirable to lead HUNDRED in conditions.

4 Note on a windscreen the provision of a brush of a screen wiper. For this purpose near a brush paste on strip glass.

5 Remove a cover screw-driver from screen wiper fastening at the left and on the right.

6 Unscrew nuts-1-.

7 Remove both levers by means of a usual stripper from axes.

Levers sit very strongly and do not act in film without the special tool. The opening of cams of a stripper should be not less than 16.3 mm. On an accompanying illustration BMW stripper – 616000 is represented. However it is possible to apply also the HAZET 1966-5 tool.

On an illustration, for an example, the lever of other car is shown.

8 Take out adjusting plugs from cleaner levers.


 INSTALLATION

9 Establish into place the lever and expose it according to the markings put on a windscreen.

10 Establish on an axis-2-the adjusting plug-1-and press it aflush with the lever - 3-.

11 Fix the lever the moment of 25 N • m and through 15 mines once again the moment of 25 N • m.
12 Put a cover on a fastening nut.
13 Similarly establish the second lever.
14 Attach a negative cable (-) the storage battery at the switched-off ignition. Establish hours.