E46 series BMW 3

1 Mark paint the provision of a forward wheel concerning a nave. It will allow to establish an otbalansirovanny wheel in the former situation. Weaken bolts of fastening of a wheel at the car standing on the earth. Lift a forward part of the car and remove a wheel.

2 Measure the size - And - between the hinge and the end of a carving of steering draft - 5-also write down the received value.

3 Weaken a tightening nut-1-tips of steering draft-2-, address to the Section Corners of installation of forward wheels. Check of installation of wheels.

4 Unscrew a nut of fastening-3-hinges of steering draft-4-. 2–tip of steering draft.

5 Remove a tip of steering draft by means of the HAZET779 tool – 1.

6 Unscrew a tip from steering draft, keeping thus draft a wrench for a shestigrannik-5-from a provorachivaniye.

At an otvorachivaniye count number of turns and write down the received value. It will facilitate further adjustment of forward wheels.

7 Establish on steering draft a tightening ring if it acted in film.
8 Screw a tip of steering draft, the number of turns should be equal to number of turns at removal. Check the size - And - received before removal.
9 If it is necessary, clear of greasing a pin of the hinge of steering draft, and also an opening in a rotary fist.
10 Insert a tip of steering draft, and also an opening into a rotary fist. Screw a new being self-stopped nut on a pin of the hinge and tighten it the moment of 65 N • m.
11 Tighten a tightening nut of a tip of steering draft the moment of 80 N • m. Thus keep draft from a provorachivaniye for a shestigrannik.
12 Establish into place a wheel so that the markings put at removal, coincided. Previously grease with a thin layer of bearing greasing a seat of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace with the new. Fix a wheel bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 100 N • m.
13 Check a track on HUNDRED, if necessary adjust.