E46 series BMW 3

1 Remove directing brakes with a support and the inserted blocks and adhere them a wire to a suspension bracket. A brake hose do not disconnect, otherwise after installation it is necessary to delete air from system.

2 Turn out the screw of fastening by-4-face key and on 5 mm.

3 Remove a brake disk.

Ventilated brake disks отбалансированы. It is not necessary to take out or displace balancing brackets on internal diameter of a brake disk.

For achievement of uniform braking from both parties both brake disks should have an identical surface concerning quality and a roughness. Therefore surely it is necessary to replace or pierce both brake disks.

At check of disks on palpation, address to Specifications for its admissible values.

1 Measure thickness of a brake disk, address to the Section Measurement of thickness of a brake disk.
2 If there is a rust on a flange of a disk and a wheel nave, remove it.
3 Clear a nitrothinner new disks of a sheeting.
4 Establish a disk on a nave and turn so that openings under bolts coincided. Tighten bolts a face key the moment of 16 N • m.
5 Establish into place a brake bracket with a support and the inserted blocks, address to appropriate section.
6 New brake disks it is necessary to earn extra carefully for three receptions. First reception: five braking since speed of 50 km/h in strong pressing a brake pedal on the road where there is no traffic. Second reception: Let's to brakes be cooled. Third reception: 5 more braking since speed of 50 km/h.