|
|
E46 series BMW 3since 1998 of releaseRepair and car operation |
|
|
E46 series BMW 3 + BMW 3 Cars (E46) + Current leaving and service + Engine + Systems of cooling, heating - Power supply systems, injection and release Security measures and rules of observance of purity at work with fuel system Removal and installation of the sensor of a stock of fuel / fuel pump Check of the sensor of a stock of fuel + Power supply system of petrol engines - System of injection of fuel of the petrol engine The general information and security measures at work Principle of work of DME system Removal and installation of injectors Check of system of injection of the petrol engine Check and adjustment of turns of idling and concentration WITH + Power supply system of diesel engines + System of production of the fulfilled gases + engine Electric equipment + RKPP and transmission line + Automatic transmission + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + electric equipment Schemes 
|
System of injection of fuel of the petrol engine The general information and security measures at work The car is equipped with an electronic digital control system of the engine (DME/BOSCH-MOTRONIC).The electronic control system of the engine allows to realize the following advantages: - An exact dosage of fuel in any mode of operation that provides small fuel consumption at high capacity. - Reduction of the content of harmful substances in the fulfilled gases thanks to exact dispensing of fuel and use of the catalytic converter. - Self-diagnostics of a control system by the engine, provides possibility of fast troubleshooting. The control system of the engine has memory of malfunctions. If defect in use comes to light, it is brought in memory of the device. If the engine has malfunctions, by means of the special device it is possible to deduce their list, allowing to reveal and eliminate defect independently. Address to the Section Diagnostics of malfunctions. Work it is desirable to lead HUNDRED in conditions. The control unit the engine represents the minicomputer with high speed. It defines optimum time of injection and amount of injected fuel. Thus there is a coordination of operation of the control unit with other systems of the car, for example, to a control system of a check point or blocking from stealing. Elements of a control system of the engine keeps the high performance for a long time and practically does not demand service. Replacements at carrying out maintenance demand only the air filter and spark plugs. Serious works on adjustment and repair demand use of difficult diagnostic devices. Address to the Section Diagnostics of malfunctions. Adjustment of number of turns of idling and concentration WITH within carrying out maintenance is not required. Security measures at work with a control system of the engine / the petrol engine The fuel system is under pressure! When opening system fuel emission is possible. Therefore the flowed-out fuel is necessary for wiping a rag. Pairs of gasoline are poisonous and is combustible. Use goggles. Watch good ventilation of a workplace. Have on call the fire extinguisher. For an exception of a travmirovaniye of people and/or damage of system of injection and ignition it is necessary to observe the following: - Do not concern and do not disconnect ignition wires at the working engine or at the included starter. - Disconnect and attach pipelines of system of injection and an ignition wire, and also electric wires of devices of measurement only at the switched-off ignition. - It is not allowed to work with electronic system of ignition to people with a warm stimulator. - At check of a compression it is not allowed to make fuel injection.
|
|