|
|
E46 series BMW 3since 1998 of releaseRepair and car operation |
|
|
E46 series BMW 3 + BMW 3 Cars (E46) + Current leaving and service + Engine + Systems of cooling, heating - Power supply systems, injection and release Security measures and rules of observance of purity at work with fuel system Removal and installation of the sensor of a stock of fuel / fuel pump Check of the sensor of a stock of fuel - Power supply system of petrol engines Removal, installation and check of the relay of the fuel pump Removal and installation of the fuel filter Removal, installation and adjustment of a drive of a butterfly valve Removal and installation of the air filter of the engine + System of injection of fuel of the petrol engine + Power supply system of diesel engines + System of production of the fulfilled gases + engine Electric equipment + RKPP and transmission line + Automatic transmission + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + electric equipment Schemes 
|
Power supply system of petrol engines
1 Lift and establish the car horizontally on supports. Remove the bottom cover of an impellent compartment, address to the Section Removal and installation of the bottom cover of an impellent compartment. 2 Establish the selector in the situation "R".
4 Wring out the lever of a box-3-forward in the provision of a parking. Thus pull a cable-4-in an opposite direction and again release it. 5 Tighten a nut-2 - the moment of 10 N • m, holding thus the tightening plug-1-for a shestigrannik. 6 Check operation of the selector. For this purpose include ignition. At the motionless car the selector can move from the situation "R" or "N" if the brake pedal is at the same time pressed. 7 Engine can be started only in position of the R and N selector. 8 Ignition key can be taken out only in position of the selector "R". 9 Otherwise it is necessary to address on HUNDRED. |
|