E46 series BMW 3
+ BMW 3 Cars (E46)
+ Current leaving and service
+ Engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ engine Electric equipment
- RKPP and transmission line
Removal and RKPP installation
Removal and installation of the lever of gear shifting
Check of level and oil replacement in RKPP
Removal and driveshaft installation
Differential and adjustment of gear wheels of the main transfer
Check oil level/replacement in a reducer of the back bridge
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes
|
Removal and installation of the lever of gear shifting Gear shifting drive
|
| 1 — the switching lever
2 — the basic plug
3 — a basic finger
4 — a support
5 — the gear shifting lever
7 — a support
8 — a cover | 9 — draft of switching
10 — a remote ring
11 — a lock washer
12 — the hinge of draft of switching
13 — a lock ring
14 — a washer
15 — a pin |
| |
| 1 Pull strongly the handle up, without rotating it thus. Remove a lever cover at the central console and remove it from the switching lever. The specified works are described in the Section Removal and installation of the central console, address to the Section Removal and installation of the central armrest.
| | Operation of lifting and car installation on supports is connected with danger! Therefore before carrying out operation familiarize with Poddomkrachivaniye's Section and towage | 2 Lift and establish the car on supports. Remove system of release and the thermofilter under the gear shifting lever, address to the Section Removal and installation of system of release.
|
3 Remove from the bottom party of the car a lock bracket-1-. Remove a washer-2-. Take out sideways draft of switching-3-. |
|
4 Put from below on the switching lever a tsapfovy wrench, for example, BMW 251110 and turn it on a corner 90 ° counter-clockwise. After that wring out up from the lever the spherical loose leaf. | 5 Disconnect at a body a cover of the lever of switching and take out it up with the lever. | |
| |
| 6 Grease spherical loose leaves of the lever with KLUBER POLZLUBE GLY greasing.
|
7 Establish the switching lever with the spherical loose leaf so that shooters on the loose leaf showed in the direction of a longitudinal axis of the car (the shooter on an accompanying illustration). Pads of the spherical loose leaf settle down across the car. |
|
8 Press from above the loose leaf a screw-driver in the holder so that pads were distinctly fixed. |
|
9 Fix a cover. The arrow on a cover should indicate forward, in the movement direction. Insert an internal board of a cover via the lever, and external into body cut. | 10 Insert a finger of draft of switching into the lever, having put washers. Establish a lock bracket.
11 if necessary establish the thermofilter and release system, address to the Section Removal and installation of system of release.
12 Fix a cover of the lever of switching on the central console. Put on the lever the handle and strongly press on it, address to the Section Removal and installation of the central armrest. |
|
|
|
